today i had some time off so i did:
1)parked the car on a level surface and measured the distance from centre of hub to the arch to be 54,5cm
2)lifted the truck with both wheels off the ground, remeasured the distance from centre of hub to the arch to be 59,5cm
3)took off wheels
4)disconnected the front sway rods
5)took the whole sway (stabilizer) bar off because it was in the way of the arms
6)shaved the bump stops another half an inch (there is approximately 5-6cm distance between bump stops and bottom arm)
7)put the wheels back
8)did the measurements again as in 1 and 2 and gave me exactly the same results
didnt do the ball joint flip because i didnt have the new tyres yet and i dont want to pay an extra wheel alignment for these tyres now and in a few days for the new ones again.
so basically now im completely lost.i dont know what else to do in order to get some decent flex on my truck.what went wrong?and more important what do i do to fix this?
ANYBODY?ANYTHING?