I'm replacing the bottom A-Arm in the front of my UBS69 Bighorn. Some people might might call it the Lower control arm.
After removing the arm and torsion bar etc.. I now have to press out the bushes that are in the mounts connected/welded to the chassis.
Bloody tight!!!!
Making up a puller by machining down a 1" 3/8 socket to suit. The front and rear bushes are different sizes if anyone needs to know.
Anyone else changed these?
Reason for changing bushes is because my drivers side front wheel moves up and down as per normal, BUT is moving backward a fair bit too.
Tyre rubs on inner gaurd sometimes and the left side isn't as bad.
I've had someone else driving it a hill while I was watching and backward movment is very noticeable