• Advertisement

Maxtrax / tred and chainsaw holder.

Share and discuss mod ideas here that make your Isuzu safer, faster, more homely, more user friendly or just crazier! The best from here will be made into a full DIY write up for the FAQ and DIY mod section.

Maxtrax / tred and chainsaw holder.

Postby topgun94 » Sun Sep 06, 2015 9:01 pm

Mad up / Installed the tred and chainsaw carrier. Came up a treat!
The Chain saw Is secured to the car using stainless steel wire and a padlock (blue Circle).
Then to secure the chainsaw in position a d-shackle was welded upside down making it easy to remove and take the chainsaw out! (Red circle)
If you also look hard on the front view you can see a small steel peg protruding. This is to keep the chainsaw in position aswel
When the treds are on you cannot see the chainsaw from the back!
10.jpg
11.jpg
12.jpg
22.jpg
You do not have the required permissions to view the files attached to this post.
User avatar
topgun94
Isuzu Senior
 
Posts: 190
Joined: Tue May 14, 2013 9:30 pm
Age: 22
Country: AUSTRALIA
City: BRISBANE
Vehicle: 1991 ISUZU MU. 4JB1T, Boosted, Intercooled, MIG front locker, Rear LSD, Reduction Gears, Stock Height but 33" muds

Re: Maxtrax / tred and chainsaw holder.

Postby MUVIT » Sat Sep 12, 2015 10:53 pm

well done
MUVIT
Isuzu Guru
 
Posts: 539
Joined: Thu Nov 19, 2009 2:35 pm
Age: 27
Country: Aus
City: Darwin
Vehicle: Isuzu MU 96

Re: Maxtrax / tred and chainsaw holder.

Postby turnturn » Sun Sep 13, 2015 6:23 am

Do you have to lower your tailgate glass a bit before closing the tailgate?
User avatar
turnturn
Global Moderator
 
Posts: 950
Joined: Wed May 13, 2009 4:26 pm
Age: 57
Country: New Zealand
City: Dunedin
Vehicle: 1992 Isuzu Mu 2.8 Manual (UCS55)
Snorkle, Intercooled
1993 Isuzu Mu 2.8 Manual (UCS55)
Spare Parts/Donor
1994 Isuzu Mu 3.1 Manual (UCS69)
Snorkle, Intercooled
1996 Isuzu Mu 3.1 Manual (UCS69)
Completely Standard

Re: Maxtrax / tred and chainsaw holder.

Postby topgun94 » Tue Sep 15, 2015 9:04 pm

I did have to originally partially shut the glass. But then I installed a curved corner instead of a square. Back to closing in what ever preference you desire.
User avatar
topgun94
Isuzu Senior
 
Posts: 190
Joined: Tue May 14, 2013 9:30 pm
Age: 22
Country: AUSTRALIA
City: BRISBANE
Vehicle: 1991 ISUZU MU. 4JB1T, Boosted, Intercooled, MIG front locker, Rear LSD, Reduction Gears, Stock Height but 33" muds


Return to Special Mods

Who is online

Users browsing this forum: No registered users and 7 guests

cron