Re-installing 4JB1-T - 3 cables with no home??

[BrokenMu]

Could anyone please help me with where these three would plug into?





Cheers for any help

Regards
Michael

[BrokenMu]

Ok so I couldn't work out at 2am that two of them plug into eachother

Still don't know where the one with the barrel connector goes though.

[nighthawk]

Small flat one goes oil pressure sender just under on bottom of second pic. large flat to starter motor, and the round one cant remember but close by as well, should be round male floating around somewhere good luck

[nighthawk]

oops just seen you got 2 worked out. still cant see a wire on your oil pressure sender thou

[BrokenMu]

There is a wire going to my oil pressure sender and starter solenoid I've searched for a long time and can't find a round male anywhere. I'm thinking I'll just start it up and see what doesn't work.

[pig75]

Ok you need to move the wire on the gauge sender to the light sender then make a lead that goes from that bullet plug to the gauge sender. The factory sender has the wire attached (the red circle)

IMG_1207.JPG

[BrokenMu]

Gracias!