• Advertisement

LSD Questions....

Get help fixing your Isuzu from other club members

Re: LSD Questions....

Postby geeves » Mon Dec 31, 2018 2:38 pm

Warm the diff oil in a bucket of tap hot water for 15 minutes or so. It flows easier so less likely to spill
Sanding your knuckles before starting work can help. That way you cant skin them
User avatar
Site Admin
Posts: 8282
Joined: Sun May 10, 2009 1:36 pm
Location: wellington
Age: 55
Country: NZ
City: Wellington
Vehicle: 94 bighorn
96 wizard

Re: LSD Questions....

Postby Brinky » Wed Jan 02, 2019 7:12 pm

Yey, Mu all back together and even sorted my RH hand brake cable while doing it. The rubber bellows at the caliper was torn and cable was starting to bind when releasing the handbrake. All oiled and protected with a thin rubber boot and two cable clamps. Very hard to turn one wheel now but still doesn't have enough bite to push the car in 2wd with one rear tyre off the ground. It will do for now until I get an open diff and a Lokka.
User avatar
Isuzu Baby
Posts: 23
Joined: Thu Dec 06, 2018 6:45 pm
Age: 53
Country: New Zealand
Vehicle: 1992 Isuzu Mu 2.8l UCS55
Automatic Trans, Bighorn Inter-cooled, 2" Raised Torsion's and Shackles, Shaved bump stops, Flipped top ball joints, Standard dump pipe with 2.5" exhaust, K&N filter, Snorkel, Raised Trans and Transfer Box with modified cross brace, Not lifted, 31x10.5x15 muds, Runva 9500 winch, Oil catch can, disconnected sway bar


Return to Drive train, Steering and Suspension

Who is online

Users browsing this forum: No registered users and 1 guest