• Advertisement

96 Mu - Inner CV Boot

Get help fixing your Isuzu from other club members

96 Mu - Inner CV Boot

Postby turnturn » Sun May 19, 2019 10:17 pm

I'm about to replace my inner CV boots (and outer's because I'm in there already) but I can't remember if I can get the half shafts out just by breaking/disconnecting one ball joint.

The last time I did this I was committed to taking the whole stub axle off so it wasn't an issue but this time I only really want to do the CV boots.

So my question is can I get the half shafts out by breaking only the taper on the upper ball joint or unbolting the lower ball joint (and maybe a tie rod)? If so, which one?

I'm pretty sure that I did it one of these ways years ago but have forgotten exactly how (not getting any younger....).
User avatar
turnturn
Global Moderator
 
Posts: 914
Joined: Wed May 13, 2009 4:26 pm
Age: 55
Country: New Zealand
City: Dunedin
Vehicle: 1992 Isuzu Mu 2.8 Manual (UCS55)
Snorkle, Intercooled
1993 Isuzu Mu 2.8 Manual (UCS55)
Spare Parts/Donor
1994 Isuzu Mu 3.1 Manual (UCS69)
Snorkle, Intercooled
1996 Isuzu Mu 3.1 Manual (UCS69)
Completely Standard

Re: 96 Mu - Inner CV Boot

Postby geeves » Mon May 20, 2019 8:04 am

For the boots you have to take the circlip off the inner end of the shaft so the whole axle does have to come out. Remember the spring insise the inner cv to split that joint so no need to drop the diff. My 96 Wizard I could do this by just cracking the top joint and tie rod but the 94 bighorn I have to crack all 3 joints. Bottom joint can be a little stubborn
Sanding your knuckles before starting work can help. That way you cant skin them
User avatar
geeves
Site Admin
 
Posts: 8394
Joined: Sun May 10, 2009 1:36 pm
Location: wellington
Age: 55
Country: NZ
City: Wellington
Vehicle: 94 bighorn 4jg2
2004 Honda CRV


Return to Drive train, Steering and Suspension

Who is online

Users browsing this forum: No registered users and 3 guests

cron