Tyres rubbing on chassis. Steering adjustment?

by **dasnoboarder** » Tue May 04, 2010 3:17 pm

Hey,

My front tyres are rubbing on the chassis, behind front suspension.
Only on lock with compression.

33x12.5xR15 on 15x8 with -28 offset.

Is there a steering adjustment to reduce the amount of steering angle at full-lock?
To stop the wheels just before they hit the chassis, it isn't much.

Can't think of any other solutions apart from repainting now and then :roll:

Andy.

by **turnturn** » Tue May 04, 2010 3:23 pm

Yes there are adjusters for limiting your steering lock. They are in the area between the front of your lower suspension arm and the chassis. A hex screw with a lock nut on it.

by **dasnoboarder** » Tue May 04, 2010 4:56 pm

Ah ok, cheers, I guess you adjust both sides with the same number of turns?

by **turnturn** » Tue May 04, 2010 6:45 pm

Just adjust as necessary. Not necessarily symmetrically. Just remember that you alter the passenger adjusters side to change the clearance behind the drivers side wheel.