After going out with my largest tyres on this weekend I had an ongoing problem with one rear wheel rubbing the guard. A quick measure at home shows the diff isnt sitting in exactly the same place on the left and right spring with the left being about 1 cm further back than the right. The question is though which side is wrong.
Could I get a couple of people to crawl under there trucks please and measure from the centre of the front and back eye to the centre of the diff so I can work out the correct alignment and fix. As this measurement is dependant on the set of the spring the measurements will be different but its the difference between back and front thats important
Tyres that are a true 32 inches are a tight fit on an 89 bighorn with only a 50mm suspension lift at the best of times It doesnt take much to make them rub
thanks