by damo667 » Mon Jun 19, 2017 6:33 pm
Sounds like a good project is it going to be a competition truck?!
Had a setback at the weekend on the bushes
I got it all apart and once I got the torsion bars off I realised the shop had given me 4 of the 'front' lower control arm bushes and no 'rear's
So I did the fronts a had to put it all back together again!
The fronts weren't to bad I pressed them out with a ball joint press I had and a bit of pipe I found at work, but the rears looked a lot harder, diff in the way etc..
vroom..._____________...........
vroom./---------|--------\.......
..&.....||______|_____O-\______....
....&...|--____---------------____--\..
........=\/-----\__________/-----\_|...
............\___/..................\___/...