• Advertisement

EGR Removal 1996 4jg2 Mu (3.1 auto)

Getting the best performance from your Isuzu, the in's and out's

EGR Removal 1996 4jg2 Mu (3.1 auto)

Postby MightyMO0o » Fri Feb 23, 2018 2:51 pm

Hey guys I’ve read through every thread on here to do with the Egr removal, but haven’t seen any that are the same set up as mine. It would appear I have 2 sets of solenoids (one on drivers side corner) and one where I’ve seen everybody else’s in the passenger side corner. As far as I understand if I remove all vacuum lines attaching to these 2 valves, I’m good to go? I’m not worried about the idle up for the ac. And everything I remove I just block right? Really appreciate any help, thanks guys
Kerry

P.s I just traced 2 vac lines coming from the drivers side corner set of solenoids to go to a valve looking thing on my exhaust just beside where the rear drive shaft connects to the gearbox. Does this have anything to do with it?
MightyMO0o
Isuzu Baby
 
Posts: 8
Joined: Thu Feb 15, 2018 6:18 pm
Age: 26
Country: New Zealand
City: Tauranga
Vehicle: 1996 Mu

Re: EGR Removal 1996 4jg2 Mu (3.1 auto)

Postby geeves » Fri Feb 23, 2018 4:45 pm

That one is cold start. Unless you disable the device in the exhaust leave this one alone
Sanding your knuckles before starting work can help. That way you cant skin them
User avatar
geeves
Site Admin
 
Posts: 8962
Joined: Sun May 10, 2009 1:36 pm
Location: Rangiora
Age: 63
Country: NZ
City: Rangiora
Vehicle: 94 bighorn 4jg2
2013 Subaru XV


Return to Engines and Exhaust

Who is online

Users browsing this forum: No registered users and 3 guests