by geeves » Mon Jun 24, 2024 7:22 am
front tf rodeo fine back you need to do some measurements to get the best option. Take out the bad shock and measure the compressed length mount center to pin (I think its a pin if not center to center) Jack up the back so the spring is fully extended and measure mount to mount. measure the pin diameters. Your rear shock should have the same compressed length as current and at least the same extended length as your full drop measurement plus the pins should match either with the supplied bushes or alternate bushes.
This is correct on all leaf sprung vehicles. If you have coils the spring needs to be slightly shorter than the extended length as the shock retains the coil
Sanding your knuckles before starting work can help. That way you cant skin them