This job increased a lot.. I´m sure how to do, I´m not convinced that it is cv is broken, when I drive so one wheel is slipping, it comes BAD noise from the hub/joint (?). First I thougt is was the automatic free wheel, I have loosen that, clean and tested again, same noise, but it seams working when I lift the wheel and turn around. Therefore I go for the cv joint.. but I don´t see any problem, no wear and tear, is that normal or should I find a faulty cv just by looking? I can still back of an put the part back again, but than I´m on square one again. The new cv I have is a aftermarket joint