by geeves » Tue Nov 01, 2011 1:59 pm
ok I get 200 and 310 so z = 110 According to that its sagged 20mm but the cv joints are higher at the diff than the axle and the tyres dont fill the guards very well Even my 31x10.5x15s look small in those guards. Add to that that my trolley jack which happily lifts the bighorn on 32s so the tyre is an inch off the ground wont lift the wizard on 245x70x16 which is about 28 inches without running out of travel. This is from the recommended jacking point
Can anyone with a stock coil sprung wizard please measure from the hub center to the top of the guard. Please
Sanding your knuckles before starting work can help. That way you cant skin them