isuzurob wrote:they are short, as i said when i reset my factory leaves 3 inches they were short and sometimes invert, got a cert with them in though, evryones part numbers are different, most people only have listings for tf rodeo which are almost the same
nb422 wrote:Spring over on standard leafs is worth it imo, especially if going to get it certed for a body lift anyway. Mine has 2 inch body as well as a spring over and cranked torsion to sorta level it out. Was easy as to cert too.
nb422 wrote:Raises 75mm, mines fully certified for it. Most certifiers were ok with it, only 1 of 6 i spoke to said no. Front is 45mm lower than rear with decent travel still. Did balljoint flip, no spacer required. Official measurments on the plate are rear670mm front625mm.
Dobinsons springs are good, how much lift are they?
Users browsing this forum: No registered users and 2 guests